Wood Working 12

My current project is making a nightstand with a drawer to go along with a stool project I’m making so it’s like a set. The actual process of breaking out the pieces went perfectly and when I assembled it, I thought it fit together well, but when I unclamped it notice there was a gap between the back panel and the side of 1/8 so I had to find something to fill in the gap. So rather than cutting out a new piece, I thought I could probably find a piece that could fit that 1/8 hole because that’s a pretty even measurement so I went to the table saw bin and found a piece of scrap that was 1/8 by 8 inches and cut it down on the scroll saw to the proper length

print

Leave a Reply

Your email address will not be published. Required fields are marked *