For my rose/vase project in metal art I learned how to use a lot of different tools. I learned how to use a sawdering iron, a MiG welder, wire wheel, jeweler torch, and a sander/grinder. I learned all the basic skills for these tools/machines and I practiced using them. I also learned all the safety procedures for all the machines/tools. I took all the quizzes for each machine to make sure I understand all the safety procedures. The things I like about my project are my MIG welds because they were all small welds which aren’t very noticeable. I also like how clean my project was at the end. I spent a lot of time to make sure there was no dirt or grime on any of the metal. I didn’t really like my sawders because the metal wasn’t hot enough for the sawder to work properly. So their was a lot of sawder around the leaf in the middle of the rose. Overall I was quite happy with how it turned out.